Tuesday, December 28, 2010

Santa Card


Santa Card

This card was inspired by a couple of cards I saw on-line, but I added my own twist to them, using the Divine Swirls embossing folder and a corner rounder, and adding a hat completed with a pompom.

Materials

  • Paper and Cardstock
    • White Card-stock
      • 4 1/4" x 11" for card base
      • 4 1/4 x 5 1/2 for beard, moustache, and hat brim
      • Small scrap for eyes
    • Black Card-stock, small scrap for eyes
    • Bazzill Singles
      • Sweet Pea,   4 1/4" x 1 13/16", plus a small scrap for the nose
      • Diablo,   4 1/4" x 1 13/16", and 3 3/4" x 1 5/8" then cut on the diagonal to form a triangle.
  • Inks and Embossing Powders
    • Distress Inks
      • Tattered Rose
      • Weathered Wood
  • Embellishments
    • Small white pom pom
  • Tools
    • Provo Craft Cuttlebug Machine
    • Provo Craft Cuttlebug A2 Embossing Folder, Divine Swirl
    • Crop-A-Dile Corner Chomper, corner rounder
    • Punches
      • EK Success Nesting Punches, 1 1/2" x 3/4" Oval
      • EK Success Circle, 5/16"
      • EK Success Circle, 1/2"
      • EK Success Circle, 1"
    • Fiskars Decorative Edge Scissors, Cloud
    • Ultimate Gel Pen, White Pastel
    • 3" round hydra sponge
  • Adhesives
    • Aleene's Tacky Glue
    • ATG-714 Double Sided Adhesive Tape Gun for 1/4" tape, with tape
    • 3-D Large Circle Foam Dots
  • Other

Instructions

  • Make the eyes.
    • Punch two 1/2" circles out of black card-stock.
    • Punch two 3/8" circles out of black card stock.
    • Punch two 3/8" circles out of white card stock.
    • Layer a white circle centered on each of the 1/2" black circles
    • Layer a small black circle over the white circle, offset so a crescent of the white circle is visible, on each eye.
    • Opposite from the white crescent, draw a small arc of white with the white gel pen, on each eye.
    • Set eyes aside.
    •      
  • Punch a 1" circle out of the scrap of Sweet Pea card-stock for the nose. Sponge rose distress ink around the edges.
  • Sponge two circles of rose distress ink onto the rectangle of Sweet Pea card-stock, about an inch from the center horizontally, and just below center vertically. These will be Santa's rosy cheeks.
  • Attach the Diablo rectangle to the front of the card base right at the top of the card.
  • Attach the Sweet Pea card-stock rectangle to the front of the card base, just below the diablo rectangle.
  • Run the quarter sheet of white card-stock through the CuttleBug, inside of the Divine Swirls embossing folder, according to manufacturer's directions.
  • Cut the embossed paper into two pieces, 4 1/4" x 4 1/4" square and 2 1/4" a 4 1/4 ".
  • Use the Cloud scissors on the 2 1/4" x 4 1/4" piece of embossed card-stock to create a band for Santa's Hat, roughly 1/2" wide or a little wider.
    Sponge the edges of the band with Weathered Wood ink.
    Attach to the card, slightly overlapping the Sweet Pea Rectangle.
  • Use the beard template to cut the square piece of embossed card-stock to make Santa's beard.
    Sponge around the edges of the cut arch with the Weathered Wood ink.
  • Use the remaining scrap from the beard to punch the two ovals for Santa's moustache.
    Sponge around the ovals with the Weathered Wood ink.
  • Attach the beard at the bottom of the card, with the top of the beard barely overlapping the Sweet Pea strip.
  • Sponge the hypotenuse (the slanted side) of the Diable triangle with Weathered Wood ink. Here are the parts that have been sponged so far, excluding the beard.
  • Attach the triangle of Diablo card-stock to the top left side of the card, point down.
  • Corner round all of the corners of the card using the 1/2" side of the Corner Chompers.
  • Sponge Weathered Wood ink around all of the card edges.
  • Attach Santa's nose to the lower center of the Sweet Pea part of the card front, just above the beard, using a 3-D foam dot.
    Attach the ovals below the nose to make the moustache.
    Attach the eyes above and to each side of the nose.
  • Attach a pom pom to the end of the triangle to finish Santa's hat.
  • On the inside, stamp a sentiment of your choice. My favorite is a simple "Ho Ho Ho."

5 comments:

  1. I am so overwhelmed with your work I love it.
    I am having a my birthday blog hop. I was wondering if you would like to be in it with us.

    Thank Debbie

    ReplyDelete
  2. Way to cute card. I love how you did the eyes. You have wonderful instructions.
    I am looking forward to being in the Birthday Blog Hop for Debbie. I a sure we are going to have a ton of fun.
    TFS!
    Cindy
    http://scrappinc.blogspot.com

    ReplyDelete
  3. OMG he is just too cute. I am blog hopping and you were next on the list. Thanks for sharing.

    Mindy - The Determined Scrapper
    http://thedeterminedscrapper.blogspot.com

    ReplyDelete
  4. I really like the simplicity of this card. I will definately try to do this. thx

    ReplyDelete
  5. I love this Birthday album. What a unique idea.. I am a new follower and cannot wait to see more.

    ReplyDelete